EN
Good acoustic wood wall panels can help in soundproofing your space, so it is important to do it right. It’s easy to overlook simple errors that may allow sound to slip through. Below is a guide on how to avoid those missteps and achieve the best outcome when using your JIANG FEN BEI Acoustic Foam panels.
Positioning Of Panels For Best Soundproofing
For keeping out noise, it’s critical to get those panels aligned just right. If they are the tiniest bit out of place, sound can slip through. Begin by making certain the first panel is plumb and straight, use a level on the wall. Then, butt up each new panel tightly against the last. That way, you can form a solid noise barrier.
Avoiding Gaps and Overlapping Panels
For example, an often seen error is small empty spaces between the panels or slight overlapping among them. Now cracks like these can be a big deal, because they’re the places that let the sound in. Ensure careful measurement and cut your panels correctly. If you’re not sure, opt for cutting a piece a little big and trimming it down than for cutting a piece too small and creating a gap.
Applying the Proper Adhesive for Secure Mounting
The choice of glue or adhesive that you use is of the utmost importance. Others like to use what they have lying around, but that may not secure the panels as well. JIANG FEN BEI suggests an adhesive which you can use a special adhesive of "acoustic panels". This will ensure sound absorbing wood wall panels your remain in place and don't allow sound to come through.
Edges and corners can be difficult spots from which sound enjoys getting out. It’s wise to seal these zones extra well. You could fill any minute gaps with acoustic sealant or caulking. When you seal these JIANG FEN BEI acoustic wood wall panels, you do your part in making the room quieter.
Keeping Tiles Straight and Level for Best Audio Results
Finally, ensure that your panels are not only aligned with one another but are also straight and level on your wall. If those are the surfaces are out of plumb (leaning) or not level, they won’t do as good a job as blocking sound. Use a level to eyeball each panel as you go. This may make assembly a tad slower, but the extra noise-insulation is worth it.